5S Components - Quality Electronic Components for Power Electronics Applications

Quality Electronic Components for Power Electronics Applications

 

Model # EM010TENHP1N



  • Closed loop Hall effect technology also allows for voltage measurement.
  • For calibrated EM010 sensors, the voltage to be measured is applied directly to the primary terminals of the sensor.
  • On the other hand, for not calibrated EM010 sensors, an external input resistor must be inserted in the primary before connecting the voltage to be measured.
  • Warning :

    The voltage UP to be measured cannot be directly applied to the primary terminals marked «+» and «-» for not calibrated EM010 sensors. In order to use these not calibrated EM010 sensors for voltage measurement, an input resistance RE must be added to the primary (see diagram below). The voltage rating is determined from the value of this resistance RE


Specifications
CalibratedNo
Nominal Primary Voltage (Vpn)N/A
Measuring Range (Peak)20 mA
Secondary Current at VPN (mA)N/A
Supply Voltage (DC)±12 to ±24 V
Product TypeVoltage Sensors
Min. Measuring Resistance at ±15 V0 O
Primary Turn Number10000
Secondary Turn Number2000
Accuracy at UPNN/A
Offset Current= ±0.3 mA
Linearity= ±0.1 %
Thermal Drift Coefficient (-25 to 70°C)= ±5 µA/ºC
Delay Time= 100 µs
Max. No-Load Consumption Current at ± 12 V15 mA
Max. No-Load Consumption Current at ± 24 V25 mA
Primary Resistance1.5 kO
Secondary Resistance60 O
Dielectric Strength Primary/(Secondary-Screen-Ground)6 kV
Dielectric Strength Secondary/(Screen-Ground)N/A
Voltage Drop= 1.5 V
Mass0.350 kg
Operating Temperature-25 to +70 ºC
Storage Temperature-40 to +85 ºC
Primary Connection2 inserts M5 studs
Secondary Connection3 x M5 studs
Ordering CodeEM010TENHP1N
Mounting TypeClosed Loop Hall Effect Technology
Overload (Peak)20 mA
Max. Measuring Resistance at ±12 V40 O
Max. Measuring Resistance at ±24 V160 O
Secondary Current at IPN50 mA
Accuracy at IPN= ±1 %
FeaturesGeneral Data Plastic case and insulating resin are self-extinguishing. Direction of the current : A primary current flowing from the primary terminal «+» to the primary terminal «-» results in a positive secondary output current from terminal M. The internal electrostatic screen between the primary and secondary is linked to the secondary terminal «-» (negative supply terminal). Protection of the power supply against polarity reversal. Burn-in test in accordance with FPTC 404304 cycle. Ti

5S Components Co.

5S Components Inc is a result of a management buyout of ABB Semiconductors Inc. by John Siefken and Kenny Stephenson. Effective December 1, 2005, 5S Components became the successor to ABB Semiconductors Inc. Kurt Hoerhager, Managing Director of ABB Switzerland Semiconductors and Roland Villiger, Director of Sales, commented that “Creating 5S guarantees focus on semiconductor sales in North America, a vital part our growth strategy.

Contact Info


  

5S Components Co.
630 Fifth Avenue,
East McKeesport, PA 15035

  

412-967-5858

  

412-967-5868